Hey guys. I have a 1996 Vulcan 500 and I am needing to buy a manual for it, but have no way of discerning which type of vulcan it is. Do any of you know a way of discerning this?
I also have another problem, and this is why i need the manual in the first place, where fuel keeps flowing out of the carboretur into the airbox even when the throttle isnt engaged. I thought it was a stuch float but after cleaning the carb i am left with question marks. Any of you have this issue? As it stands, i am left assuming that there is something wrong with the vacuum on the bike and that the online ltd manual doesnt have the correct setup. It is my hope that i am doing something wrong and that there isnt something wrong with the bike.
Any input is greatly appreciated. Thank you.
LTD or not?
Re: LTD or not?
Welcome.
The 'C' model (aka LTD) has the speedometer on the fuel tank whereas the 'A' model has it on the handlebars. The 'spec tag' on the steering neck will have the designation on it also.
Regarding fuel leaking from the carburetor, does this happen while it is running or while it is being stored? If it happens during storage this is a known issue with this bike and storing it with the fuel cap open seems to prevent it from happening.
Regarding manuals I prefer the factory service manual over the Haynes/Clymer service manuals. The part number is 99924-1194-xx <-version number
The 'C' model (aka LTD) has the speedometer on the fuel tank whereas the 'A' model has it on the handlebars. The 'spec tag' on the steering neck will have the designation on it also.
Regarding fuel leaking from the carburetor, does this happen while it is running or while it is being stored? If it happens during storage this is a known issue with this bike and storing it with the fuel cap open seems to prevent it from happening.
Regarding manuals I prefer the factory service manual over the Haynes/Clymer service manuals. The part number is 99924-1194-xx <-version number
--
'Biker' Bill
'97 EN500LTD 'Hidalgo'
271,000+ miles so far
VROC #3833
IBA #635
SlipStreamer Enterprise II, Vista Cruise,
Cobra Spots, Drifter solo seat,
Pro-Tac backrest, ScottOiler,
F&S luggage rack, LED lights,
4-gal AUX fuel tank
'Biker' Bill
'97 EN500LTD 'Hidalgo'
271,000+ miles so far
VROC #3833
IBA #635
SlipStreamer Enterprise II, Vista Cruise,
Cobra Spots, Drifter solo seat,
Pro-Tac backrest, ScottOiler,
F&S luggage rack, LED lights,
4-gal AUX fuel tank
-
- Posts: 3
- Joined: Sat May 14, 2016 1:01 pm
- I ride: Red Vulcan 500
Re: LTD or not?
Thank you very much. So i definitely have the ltd then. As for the leak. it leaks both when it is on and when it is off. When it is on it is less noticeable but definitely there. After a little over an hour of riding i try to start it after it being off for a bit and it acts like i flooded it. Currently i have to clamp off the fuel line just to get it to stop.
Re: LTD or not?
Did you check to make sure the fuel petcock is in the On or RES position and not in PRI (prime)? In Prime position, the fuel is in a free flow with no flow control. It could easily overfill the carbs.
- Triangles
- Site Admin
- Posts: 819
- Joined: Sun Dec 27, 2009 10:35 pm
- I ride: '94 Black Cherry Vulcan 500, '06 Candyfire Red Vulcan 500 LTD
- Location: Toledo Ohio
- Contact:
Re: LTD or not?
You said you cleaned the carbs. That won't do anything to fix your problem. You need to replace the float needle valve. Then tweak it to make sure the fuel level is proper in the bowl. Either that or your float has sprung a leak and is no longer floating. A company called K&L makes a float valve kit. I don't know the part number of the top of my head. In the technical part of this forum look in the fuel section. I think this has been covered there.
-
- Posts: 3
- Joined: Sat May 14, 2016 1:01 pm
- I ride: Red Vulcan 500
Re: LTD or not?
Thank you both very much. I ordered the manual that was suggested. Then ive ordered a carb kit, though i now realize that they only sell what are called 'economy carb kits.' Hopefully that includes the float needle triangle is talking about. Ima give this all a shot and get back to you guys. I really hope that I can get it all fixed up.
- Triangles
- Site Admin
- Posts: 819
- Joined: Sun Dec 27, 2009 10:35 pm
- I ride: '94 Black Cherry Vulcan 500, '06 Candyfire Red Vulcan 500 LTD
- Location: Toledo Ohio
- Contact:
Re: LTD or not?
the float needle looks like this. Not an endorsement of the site just what I found first in google. I don't remember if the kit for our bikes includes a new brass seat or not. If it doesn't make sure there is no corrosion on the brass seat otherwise the new float needle will likely leak too. Also check your oil. The extra gas leaking in the carbs can go into the cylinders and wash past the pistons diluting your oil. As you can imagine gasoline does not lubricate like oil does... It might be cheap insurance to just change your oil after you've verified the carbs aren't leaking anymore.
Return to “General Discussion”
Who is online
Users browsing this forum: No registered users and 1 guest